Sometimes also called soffit board fascia is a board running horizontally under a roof edge.
Fascia board demensions behind gutters.
Replacement fascias do vary in thickness by manufacturer but the rule of thumb is that to qualify structurally as a replacement board they should be somewhere between 16mm and 25mm thick our most common range is the 18mm replacement fascia.
I think mine were 3 inch wide.
Sometimes there are two fascia boards either the same width or different widths with a narrower board in front of a wider board and sometimes fascia is installed over a board of framing lumber called subfascia that mounts directly to the rafter tails.
Ideally gutters should slope down toward downspouts 1 in.
Drive 1 2 nails in per rafter so it doesn t move around.
The board that rests behind your gutter is called a fascia board.
The primary use of all fascia boards is to help secure the roof s gutter.
When you last painted your house did you take your gutters down and paint behind them.
Typically consisting of wood wood substitute or metal the fascia board along with the soffit encloses the attic space of the home.
I think mine were 3.
Place your nails in line with the marks on your drip edge and place it in the center of your fascia board.
If you are hanging gutters on the fascia you will probably want ot go with something a bit larger than 3 inches.
And it doesn t stop there.
Third it never gets any paint.
During house construction fascia boards are fastened to the ends of the rafters called rafter tails before the roofing and gutters are installed.
Second it is in an area that is constantly wet or damp.
First since it s always covered by a gutter it is never exposed to sunlight.
They hold up your gutters and are connected to your soffits or the part below your gutters.
It lives with some unique problems.
Pvc as a fascia material.
It s your choice whether to use rough sawn or smooth lumber.
Use 1 2 nails through each rafter to secure your fascia board.
They are the strips situated at the point where the roof meets the outer wall of the house to cover the ends of the roofline.
Hold the board in place and use 2 in 5 1 cm nails and a hammer to secure it in place.
The fascia is commonly helps to hold up and stabilize gutters.
As long as there is a slight pitch say 1 2 in.
Next to a level fascia board the steeper the slope of the gutter the more it looks out of whack.
Some of the water may leak behind the gutters down towards the soffit and the fascia.
It covers the openings between the rafters of the roof.
The width depends on the width of the rafters but since builders generally use two by six or two by eight lumber for roof construction the most common dimensions for fascia boards are one by six and one by eight inches.
For starters this may not look good.
Per 16 ft but this is not always possible.
Gutter brackets can be screwed directly into a replacement fascia board anywhere along its length using 25mm screws.
What is standard size of fascia board for gutters.
